At present, I am using the following equipment in the amateur radio communication:

The ID-52E is a compact analogue/digital handheld radio for on the go.

The powerful 2-band (0.1W small power, 5W normal power) allows transmitting on

- 2 m (144-146 MHz)
- 70 cm (430-440 MHz)

in analog FM and digital DSTAR.

The YAESU FT2D is a small, compact digital/analog handheld radio for on-the-go use.

The powerful 2-band (max. 5 W output power) enables transmission operation in C4FM/FM on

- 2 m (144-146 MHz)
- 70 cm (430-440 MHz) and

Receiving is possible from 500 kHz to 999 MHz.
Receiving is also possible in automatic mode. This means that the FT2D automatically detects analog FM signals and digital C4FM signals.

It has a GPS receiver and enables APRS.

The Baofeng UV-3R transceiver is an extremely small walkie-talkie.

Transmit power is about 2 W.

The frequency range covers the 2 m- and 70 cm band.

The transmit power can be reduced a little.

The IC E90 is a small, compact walkie-talkie for outdoor use.

The powerful Tri-Band-Transceiver has an output of 0,5 W (low power) and 5 W (at normal power).

Transmitting is possible at

2 m (144-146 MHz)
70 cm (430-440 MHz)
6 m (50-52 MHz, transmit mode F3E on 6m is permitted here in Germany at present).

Receive mode is possible from 495 kHz to 999.990 MHz.

I use a Kennwood TS-770E transceiver at home in the 2 m and 70 cm band.

The output of the TS-770E is about 1 W (low power) and 10 W (at normal power) in SSB, CW and FM.

I have attached the optionally available external loudspeaker SP 70.
This speaker improves the quality in the receive mode.

On short wave I use a Kennwood TS 830-S.
At the moment I operate the transceiver mostly on the 20m-band.

The transceiver is built up in hybrid technology:
The Receiver uses semiconductor technique.
In the sending part are transmitting tubes.

The TS 830-S operates on the following bands:

As modes are possible SSB and CW.

I use a Yaesu MD 200 A8X microphone besides the original hand microphone.

My HF-antenna is a modified vertical antenna / modified CB-antenna.

My (modern) all band and all mode transceiver is a YAESU FT897D.

The following modifications are made:

The FT 897D works in SSB-, CW-, AM-, FM-, and Digital modes in the bands:

I use a Yaesu FT M 10 E as a mobile equipment.

The FT M 10 E is a VHF/UHF mobile transceiver the frequency areas:
TX: 144 MHz 146 and 430-440 MHz (expandable )
RX: 0,5/1,8 (at which) 76-108 MHz/108-222 MHZ/300-999 MHz

The transmit power can be adjusted respectively in three steps and are
50/20/5 W (VHF )
40/20/5 W UHF

The following modifications are made:

My all band and all mode QRP-transceiver is a Yaesu FT-817ND.

The output power is between 0,5 W and 5 W.

The Kenwood TS-700S multimode transceiver provides 2 meter operation in FM, LSB, USB, AM and CW modes.

Power output may be selected at 1 watts (FM) or 10 watts (FM/SSB/CW) 3 watts AM.